Publicité
FEEDING
profifeed
Select a value between 1 - 99 seconds here and confirm the selection with the
You have now successfully set all parameters for the first feeding cycle and are back in
the selection (number in line „FEED" flashes).
To test a set feeding process, press the
The display runs backwards for 5 seconds until the test process starts.
If you would like to reset the proficontrol
then press the following 2 keys
Now set the desired parameters for all 6 feeding cycles. From a single fee-
ding on one day of the week to 6 feedings per day over a week, any number of
combinations can be created that are tailored to your exact needs. Once the
control is programmed, the feeding time settings are permanently stored! Even
after a disconnection from the power source. Only the system time must be set
again after disconnection.
Programming examples:
6 feedings per day, 7 days a week: Cycle 1-6, MON - SUN
1 feeding per day, 7 days a week: Cycle 1, MON - SUN, Cycle 2-6 = OFF
2 feedings per day, 7 days a week: Cycle 1,2, MON - SUN, Cycle 3-6 = OFF
3 feedings only Wednesday: Cycle 1,2,3, WEN, Cycle 4-6= OFF
1 feeding Monday, 1 feeding Friday: Cycle 1, MON, Cycle 2 FRI, Cycle 3-6= OFF
2 feedings Tuesday 3 feedings Thursday: Cycle 1,2 TUE, Cycle 3-5 THU, Cycle 6=OFF
Set the Feeding Clock Time, Feeding Duration, and Ejection Radius parameters as desired
for each cycle.
CLEANING AND MAINTENANCE
To ensure good continuity of feedings, the profifeed
ned regularly during the season. Use a small brush to remove
small brush to remove dust and feed debris from the profifeed
Feeder spreader
resistance.
Lack of maintenance or failure to perform maintenance may void the warranty.
14
ScrewFeeder
For
assembly and maintenance
the corresponding product videos in our
Youtube channel:
https://www.youtube.com/user/FIAPGmbH
(spreader plate). Note that feed can fall out of the feeder without
button.
UNIVERSAL
simultaneously for 10 seconds
please watch
ScrewFeeder
to the factory settings,
should be clea-
Screw-Solar-
GB
key.
Publicité
