Publicité
6 MACHINE-SPECIFIC SAFETY WARNINGS
▪
Hold tool by insulated grip surface when performing an operation where the cutting tool
may contact hidden wiring or its own cord. When in contact with a live wire, metallic parts
of the tool will also become live and may cause an electric shock to the operator.
▪
Do not start the tool with the blade touching any surface. The blade action will bounce the
tool and may cause body injury.
▪
Allow the tool to come to a complete stop before putting it down. A running tool will jerk
when the blade tip contacts any surface.
▪
Do not cut oversized work pieces
▪
Do not cut nails or screws unless you are using a blade specifically designed for this
purpose. Inspect your material before cutting
▪
Before switching on the tool, be sure the blade in not contacting the work piece.
▪
Keep hands away from moving parts and on the top surface of the work piece. Do not
place hands below work surface while saw is operating.
7 ASSEMBLY
Always check that the power supply corresponds to the voltage on the rating name plate.
To avoid accidental start, check to make sure lock-on button is not engaged prior to plugging
in tool and you finger is not touching the ON/OFF switch trigger (4).
7.1
Install or remove the saw blade (Fig 1)
▪
Unplug the power cord first.
▪
Rotate the Quick-release blade clamp (2) anticlockwise with hand.
▪
At the same time push blade (9) to the deepest position, then release the quick-release
blade clamp (2). Make sure it is securely fastened.
▪
When removing the saw blade (9), follow the above procedure in reverse order.
Before plugging in power cord, always pull on the blade (9) to make sure it
is securely locked in the clamp. Failure to do so may result in serious
injury.
8 OPERATION
8.1
Switch on/off (4)
▪
Connect the plug to the power supply.
▪
Turn on or turn off the tool by squeezing or releasing the ON/OFF switch trigger (4).
▪
For continuous operation just press the lock-on button (5) on the left side of the handle.
The lock-on button can be release by pressing the switch trigger again.
NOTE: This tool has a variable speed switch that delivers low speed and
higher speed with decreased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
Copyright © 2022 VARO
POWX0397
P a g e
| 5
EN
www.varo.com
Publicité
