Publicité
We remind you that the storage of foodstuffs must comply with regulatory storage
temperatures established by the National Agency for Food, Environmental and
Occupational Health and Safety (ANSES). Failure to respect these storage temperatures
involves risks of poisoning and food waste.
➢ Change the lamp
This appliance consists of light-emitting diodes (LEDs).
This type of diode cannot be changed by the consumer. The
lifetime of these LEDs is normally sufficient for no change to be
made. If however, and despite all the care taken during the
manufacture of your appliance, the LEDs were defective, please
contact your after-sales service for any intervention
5. CARE AND MAINTENANCE
➢
Cleaning and defrosting your unit
Your cooler is devised with an automatic defrosting system. Defrost water accumulates in
the channel underneath the evaporator. It is then carried to the drip tray by the help of a
hose where it evaporates.
However, after the cooler working for some time, frost will form on the surface of the
evaporator. The thicker the frost is, the hotter resistance is. The hot resistance will reduce
the effect of the refrigerant. Please defrost, when the frost is thicker than 5mm.
•
Please set the light switch to "I" and disconnect the power supply before defrosting
the cooler.
•
Use only moist cloth. use only mild soapy water.
•
Open the door, and take out the beverages. Knock the frost gently. Wait until the
defrost water is drained. Please clean with soft cloth dipping with warm water or
neutral soap liquid. Be sure to wipe with pure water after using neutral soap liquid.
•
Clean the door seal with water only.
•
Never allow the switch, control panel, cable or plug to get wet.
•
Never attempt to scrape/remove ice/frost with sharp objects (such as knives,
shovels, etc.). Or the evaporator will be broken down.
•
Wipe well with a soft cloth.
•
After defrosting, connect the cooler to the power supply and wait 2 hours before
filling it again.
CAUTION
Failure to unplug the unit could result in electrical shock or personal injury.
•
In order to optimize the energy consumption of your appliance, it is recommended
to dust the condenser located at the backside of your device.
➢
Power failure
Most power failures are corrected within a few hours and should not affect the
temperature of your unit if you minimize the number of times the door is opened. If the
power is going to be 0 for a longer period of time, you need to take the proper steps to
protect your beverages.
.
27
Publicité
