Safety Regulations; Scope Of Supply; Connecting The Remote Control - Glatz 350 01 507 100 Instructions De Montage

1. NOTES
These fitting instructions have been drawn up as a supplement to
the fitting instructions "Sunshade drive with GSS 99 control unit".
The requirements and safety regulations in both instructions
apply. This supplement must not be handed over on its own.
1.1

Safety regulations

This documentation enables the safe assembly, installation, putting into use and
operation of radio remote controls for sunshade drives of types GSS 99. The legal
requirements and regulations stated in these assembly instructions must be observed.
2.

SCOPE OF SUPPLY

• 1 2-channel receiver module with built-in antenna
• 1 hand transmitter with photo battery, 12 volt, type E23 A or 3LR50,
diameter 10.3 x 28.5 mm
• 1 mains power supply unit 12 VDC / AC
• 1 connection cable to key-operated switch
• 1 assembly instructions
3. FITTING
3.1

Connecting the remote control

It is necessary to choose a location for the radio remote control that will allow perfect
transmission of the radio signal. A check should be carried out to ensure that the
receiver module is within the transmission range.
The receiver module must be located in a dry room.
3.2 Programming of the receiver
The receiver is programmed ex works ready for operation (portable transmitter is
tuned in, both outputs are set on pulse mode). No more settings have to be adjusted.
In the case that a new transmitter has to be tuned in or the operating mode of the
output has been changed, the manufacturer's instructions are to be followed. The
adjustment must take place while the screen drive GSS99 is not connected.
4
Funkfernsteuerung zu Schirmantrieb GSS-99
Radio remote control for GSS-99 sunshade drive
Télécommande radio pour unité motrice GSS-99
Radiocomando per unità motrice GSS-99
11.2011-DEFI