Utility Drawer And Cover - Haier HTV Série Guide De L'utilisateur

English
English
To remove or adjust a full-width cantilever shelf:
(see fig. 15) (HTV16 & HTE16)
1. Guide the rear shelf hooks into the desired slots in the metal shelf supports
located on the back refrigerator wall.
2. Tilt up front of the shelf to set the shelf hooks in place.
3. Lower the front of the shelf into position until the rear hooks lock into the slots of
the metal shelf supports.
4. Lift shelf gently out of the rear shelf hooks to remove.
Utility Drawer and Cover: (HTE Series Only)
To remove the utility drawer: (see fig 8)
1. Slide utility drawer out until it reaches the stop.
2. Grasp front of drawer with one hand while sup-
porting the bottom of the drawer with the other
hand. Slide drawer out gently the rest of the
way.
To remove utility drawer cover shelf:
1. Remove utility drawer first following the above instructions.
2. Gently tilt up front of the shelf until the shelf rollers are no longer locked in place.
3. Pull the shelf gently until the rear shelf hooks are no longer locked with the rear
metal shelf support.
To install utility drawer cover shelf:
1. Guide the rear shelf hooks into the desired slots in the metal shelf supports
located on the refrigerator shelf.
2. Tilt up front of the shelf to set the shelf hooks in place.
3. Lower the front of the shelf into position until the rear hooks lock into the slots of
the metal shelf supports and the front shelf rollers are locked. Replace the utility
drawer.
11
fig. 15
fig. 8