Publicité
Chimney Connector Instructions
Type HT
Chimney System
Single Wall Chimney Adapter
Slip Connector.
Sheet Metal Screw to
Chimney Connector.
Middle Pipe Section Bottom
Fits Into Damper Section
Damper Pipe Bottom
Fits Into Unit
Unit
The above illustration represents the installation procedure for dripless pipe installation. This installation
method of installing the connector pipe with the male end down allows for any moisture to remain on the
inside of the connector pipe.
At fi rst glance you may become concerned that smoke will escape the pipe and enter the room. This is not how
the system will work. The vacuum in the chimney system will always pull air into the chimney. If you experience a
downdraft with your installation it indicates that additional chimney height or a specialty draft cap be added to your
chimney system. Contact your dealer for further information regarding downdrafts.
Attach and secure the chimney connector with a minimum of three screws to the Zircon and each adjoining section.
Material List
Included with the Zircon 34 is the following:
1 - 7 x 24 damper pipe
1 - 7 x 24 pipe section
1 -7 x 24 slip section pipe
4 - 6lb bags of Malmcrete refractory.
Page - 5
Insulated Pipe
Ceiling
Sheet Metal
Screw - 3 Minimum
Slip Connector
Dura-Vent Universal Adapter, Security
UP Adapter, Metalbestos DS-CPA ,Or
Single Wall Chimney Adapter
Zircon 30 8/20/15
Publicité
