Publicité
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Before inspecting, cleaning, or servicing the machine,
shut off motor, wait for all moving parts to stop, and
disconnect extension cord. Failure to follow these
instructions can result in serious personal injury or
property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
You can often make repairs described here. For other repairs,
have the trimmer serviced by an authorized service center.
SPOOL REPLACEMENT REEL-EASY
ADVANCE SYSTEM
See Figures 13 - 15.
If replacing line only, refer to the next section in this manual.
Use only 0.080 in. monofilament line.
Stop the motor and disconnect from power supply. Hold
the string head and unscrew the spool retainer.
Remove the empty spool from the string head.
NOTE: It is not necessary to remove the string head
housing from the drive shaft.
MAINTENANCE
Insert the new spool into the string head.
NOTE: Make sure the arrows on the spool are aligned
with the eyelets in the string head housing. Push down
and hold the spool and housing together while completing
the installation.
Reinstall the spool retainer to secure.
Install line as described in the next section.
INSTALLING LINE IN REEL EASY STRING HEAD
See Figures 15 - 17.
Stop the motor and disconnect from power supply.
Rotate the spool clockwise as necessary to align the
arrows on the spool with the eyelets in the string head
housing.
Cut one piece of trimmer line 10 ft. long. Insert the line
into the eyelet on the string trimmer housing. Push until
the end of the line comes out the other side of the string
head. Pull the line from the other side until equal amounts
of line appear on both sides of the spool.
Rotate the spool clockwise to wind the line on the spool
until approximately 6 in. of line is showing on each side.
Push the spool retainer down while pulling on line(s)
to manually advance the line and to check for proper
assembly of the string head.
INSTALLING PRO CUT II STRING HEAD
See Figure 18.
Stop the motor and disconnect from power supply.
Remove currently installed string head.
Install the string head on the drive shaft until fully seated.
Install the spool retainer and turn clockwise.
Install line as described in the next section of this manual.
INSTALLING LINE IN PRO CUT II STRING HEAD
See Figure 19.
Use only 0.080 in. monofilament line. Use quality monofilament
replacement line for best performance.
BUMP
™
Stop the motor and disconnect from power supply.
Gather two of the pre-cut lengths of trimmer line provided
or cut two pieces of trimmer line, in 11 in. lengths.
Insert the lines into the slots located on the sides of the
string head. Line should be pushed in until approximately
1 in. protrudes from the holes on the top of the string
head.
Remove old line by pulling it from the holes located on
the top of the string head.
Page 11 — English
Publicité
