Publicité
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the Packing
List are included.
WARNING:
Do not use this product if any parts in the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer in-
stallation. Use of a product that may have been improp-
erly assembled could result in serious personal injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
1-800-776-5191 for assistance.
PACKING LIST
20 Volt Power cleaner
20 ft. Quick Connect Siphon Hose w/Filter
Spray Wand
3-in-1 Nozzle (15º, Turbo, Rinse)
Brush Attachment
Foamer Nozzle
Quick Connector
Brush Adaptor
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create ac-
cessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible seri-
ous personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product when assembling parts
CONNECTING THE SPRAY WAND TO THE
POWER CLEANER
See Figure 2.
Align the arrows and insert the end of the spray wand into
the power cleaner and push it until it clicks into place.
Pull on the spray wand to be certain it is properly s ecured.
To remove, press the button on the power cleaner and
pull to remove the spray wand.
CONNECTING THE 3-IN-1 NOZZLE TO THE
SPRAY WAND
See Figure 3.
Insert the end of the 3-in-1 nozzle into the spray wand
and push it until it clicks into place.
Pull on the 3-in-1 nozzle to be certain it is properly
s ecured.
To remove, press the button on the wand and pull to
remove the 3-in-1 nozzle.
CONNECTING THE SIPHON HOSE TO THE
POWER CLEANER
See Figure 4.
The siphon hose can be submerged directly into any fresh
water source like a lake, pool, or a 5 gal. bucket for maxi-
mum portability.
Completely uncoil and straighten the siphon hose to
prevent kinks.
Align the quick connect collar on the siphon hose to the
water inlet on the power cleaner.
Push the collar onto the water inlet until it clicks securely
into place.
Pull on the hose to be certain it is properly secured.
CONNECTING THE GARDEN HOSE TO THE
POWER CLEANER
See Figure 5.
NOTICE:
Always observe all local regulations when connecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water
supply to prevent the feedback of chemicals into the
drinking water supply. Direct connection through a re-
ceiver tank or backflow preventer is usually permitted.
NEVER use hot water. Before connecting a garden hose to
the power cleaner:
Run water through the hose for 30 seconds to clean any
debris from the hose.
To connect the garden hose to the siphon hose:
Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
7 – English
Publicité
