Télécharger Imprimer la page

Hart HGPC011 Manuel D'utilisation page 10

Publicité

ASSEMBLY
NOTE: There must be a minimum of 10 feet of unrestricted
hose between the power cleaner intake and the hose
faucet or shut off valve (such as a "Y" shut off connector).
Unscrew and remove the filter from the end of the siphon
hose. Store filter for later use.
With the hose faucet turned completely off, attach the
end of the garden hose to the siphon hose water intake.
Tighten by hand.
To connect a garden hose to the power cleaner:
 Completely uncoil the garden hose or remove completely
from reel to prevent kinks.
NOTE: There must be a minimum of 10 feet of unrestricted
hose between the power cleaner intake and the hose
faucet or shut off valve (such as a "Y" shut off connector).
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result
in objects being thrown into your eyes resulting in pos-
sible serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Never direct a water stream toward people or pets, or
any electrical device. Failure to follow these instructions
could result in serious injury, electric shock, or death.
NOTICE:
Before each use, inspect the entire product for dam-
aged, missing, or loose parts such as screws, nuts,
bolts, caps, etc. Tighten securely all fasteners and caps
and do not operate this product until all missing or
damaged parts are replaced. Please contact customer
service or an authorized service center for assistance.
 Thread the quick connector onto the end of the garden
hose.
 Attach the quick connector to the water inlet on the power
cleaner.
NOTICE:
Do not run the power cleaner without water supply
connected and turned on, as this may damage the high
pressure seals and decrease pump life. Completely
unwind the hose from its reel or coil and make sure
the hose is not being restricted by tires, rocks, or any
other objects that may lessen or prevent water flow to
the power cleaner.
APPLICATIONS
You may use this product for the purpose of cleaning objects
like the examples listed below:
Patio furniture, windows, automobiles, boats, or RVs
INSTALLING/REMOVING BATTERY PACK
See Figures 6 - 7.
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
To install:
Open the battery cover by turning the lock knob and
opening the cover.
Place the battery pack in the battery compartment. Align
the raised rib on the battery pack with groove in the tool's
battery port.
WARNING:
Make sure the latch on the battery pack snap in place
and the battery pack is fully seated and secure in the
battery port before beginning operation. Failure to
securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury.
8 – English

Publicité

loading