Publicité
EN
Assembly
CAUTION: Always be sure that the tool is switched off before carrying out any work on the tool.
Installing or removing screw bit
Insert the appropriate screw bit, suitable for the intended application, into the hex bit holder. To
prevent slip or damage to the screw head, match the screwdriver bit to the head size and pattern.
Note: Use 6.35mm (1/4") hex bits only. Screw bits are a consumable item. Replace a worn screw
bit to avoid damaging the screw head or slipping out when driving.
To install the screw bit, pull the sleeve in the direction of the arrow and insert the screw bit into the
hex bit holder as far as it can go. Then release the sleeve to secure the driver bit.
To remove the screw bit, pull the sleeve in the direction of the arrow and pull the driver bit out
directly.
NOTE: If the screw bit is not inserted deep enough into the sleeve, the sleeve will not return to
its original position and the driver bit will not be secured. In this case, try reinserting the bit
according to the instructions above.
NOTE: When it is difficult to insert the screw bit, pull the sleeve and insert it into the hex bit holder
as far as it will go. NOTE: After inserting the screw bit, make sure that it is firmly secured. If it comes
out, do not use it.
Charging
Note: over the course of the full charging cycle (approximately 5~7 hours (with External USB devices) or 2~3 hours(with single charger), the battery
capacity indicator will progressively illuminate red through to green, indicating low to full charge accordingly. Before or during use, assess the charge level of
the screwdriver's battery.
1. USB Charging connection socket,
2. USB charging cable,
3. External USB devices
1. USB charging cable, 2. Power socket, 3.Charger
7
You can charge the screwdriver with various external battery-operated USB devices, e.g. notebook computer or
tablet PC only through connecting with a USB charging cable. To charge screwdriver with external USB devices,
plug one side of the charging cable into the USB Charging connection socket on the cordless screwdriver and the
other side into the USB device .
Charging with single charger
You can also charge the screwdriver with a single charger. To charge screwdriver with single charger, first plug one
side of the charging cable into the USB Charging connection socket on the cordless screwdriver and the other side
into the charger USB socket .Then plug the charger to the power socket.
Note: Due to the complex circuitry incorporated within this product. Charging must be carried
out in an environment with an ambient air temperature between 5°C to 45°C with the charger
supplied.
To prevent overheating, do not cover the charger. Attention: If the cable is damaged or the
non-self-resetting protective device is activated due to short circuit/overload the charger shall
be scrapped.
A replacement of identical specification, design and application shall be obtained.
WWW.NIKOLAOUTOOLS.COM
1. Screw bit 2. Sleeve 3. Hex bit holder
Publicité
