Impecca VP-302W Guide De L'utilisateur page 9

INSTALLING YOUR PROJECTOR
The projector can be placed on a table or other similar, stable surface. It can also be
mounted to the ceiling. Professional installation is recommended for a ceiling mount
installation.
Warning: To avoid danger, please do not install the projector near water or
extreme heat Do not block the ventilation on the back of the projector. 10 cm
(4 inches) of free space must be available around the entire unit.
DETERMINING DISTANCE AND LOCATION FOR THE PROJECTOR
You may wish to measure the distance from the lens to the surface that the image will
be projected on. This will give an idea of how big the projected image will be.
Projection Distance 1.2m
Projection Size 32 inch
Light, brightness, etc. will affect the projection distance, this data is
for reference only.
Projection Position
It is recommended to place the projector in front of the center of
the screen.
IMPORTANT: For any type of installation other than front
table projection, you will need to rotate the image. This
can be done with the Flip button, or by noting the Rotate
setting below and changing it in the Options section of
the Settings menu (covered later in the guide).
PLACING THE PROJECTOR ON A TABLE
Table Front Projection
(Rotate Setting: 0)
Table Front Projection
(Rotate Setting: 3)
2m 3m 4m
60 inch 97 inch 127 inch
Select a safe, stable surface and center the pro-
jector lens on the surface it will be projecting
on. Try to make sure that the projection surface
is parallel with the front of the projector so that
the projection is casting to the screen directly
and is not angled to the left or right.
The angle adjustment knob can later be used
to raise or lower the angle of the projector. This
will raise or lower the projected image.
9
Square/Rectangle
Screen
Projector