Publicité
OPERATION - General information
The description below corresponds to image 1 on page 2.
1. Fan blades
2. Fan housing
3. Motor housing
OPERATION - Assembling the fan
The description below corresponds to image 2 on page 2.
1. Attach the base to the base plate, using the click system.
2. Unscrew the locking ring (see figure 2A) from the shaft.
3. Fit the rear of the fan housing (2B) onto the motor-housing (2C), making sure that the openings are
aligned precisely with the lugs on the motor housing and that the grip is at the top.
4. Slide the locking ring (2A) onto the shaft, and screw it tight (clockwise).
5. Slide the fan blades (2D) onto the shaft and place the fixing knob (2E) on the shaft.
6. The rim (2F) has clamps. Carefully fit the rim around the rear half of the fan housing, making sure that
the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan housing
with the nut and bolt (2G). Use a crosshead screwdriver.
7. Close the other clamps.
OPERATION - Ventilate
The description below corresponds to image 3 on page 2.
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see figure 3). You can set the fan:
a. to blow horizontally (position a) or angled slightly downwards (position b). Tilt the ventilator housing
and motor housing to the required angle.
b. to oscillate from left to right (with a sweep of 75 °). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. remain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button until you hear it click.
3. Put the plug into the wall socket.
4. Switch on the fan by pressing one of the two speed buttons.
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at high speed.
5. Stop the fan by pressing the stop button (position '0').
CLEANING AND MAINTENANCE
Before dusting the fan:
•
Put the device in stop mode by pressing button 0.
•
Disconnect the power plug from the electrical network.
•
Wipe the exterior of the device with a dry cloth only. Do not use water or any other liquid.
•
You can clean the protective grille using a vacuum cleaner (nozzle).
•
Do not use harsh or abrasive cleaning agents to clean the device.
•
Never remove the fan protection grille to clean the blades. Once assembled during commissioning, it
must no longer be dismantled.
4. Oscillation button
5. Stop button
6. Speed buttons
14
14
7. Power cord and plug
8. Base
EN
EN
Publicité
