Publicité
Rechargeable Corkscrew Use Instructions
Children must not play with the appliance.
When the appliance must be disposed of, it is recommended to make
it inoperative.
It is also recommended to render harmless those
parts of the appliance likely to constitute a danger.
This appliance must not be used by children. Keep
the appliance and its cable away from children.
Attention: Battery life and performance can be affected by se-
veral factors, including usage time, environmental conditions,
and charge and discharge cycles. Over time and prolonged
use of the product, a natural decrease in battery performance
may occur.
Description of product Fig.A
1. Release button
2. Cork extraction button
3. Charging socket
4. Operation and charging LED
5. Foil cutter
6. USB charging cable
Recharge
Connect the USB cable to the charging port and then to a USB charging source. During recharging, the LED
red light will remain lit.
Charge the product a few hours before first use. A full charge takes approximately 3 hours. If the product has
not been used for more than a month, recharge it.
Use
With one hand, hold the bottle steady and cut the foil with the foil cutter.
Insert the corkscrew onto the bottle, making sure it stays in line with it. Press and hold the cork extraction but-
ton and gently move the corkscrew downwards. Proceed with extraction until the cap is completely removed.
The cork will be removed in about 6-8 seconds. Press the release button for 5-7 seconds to release the cap.
While using the corkscrew, always hold the bottle steady with one hand.
Technical Data
3.7V 500 mAh Ni-Mh rechargeable battery
USB power supply: 5V
For any improvement reasons, Beper reserves the right to modify or improve the product without
any notice.
7
EN
Publicité
