Publicité
TPS Operation (Tape Program
Search)
• Press 3{TPS) to activate the tape program search mode.
TPS
From the current selection, decide which program you want to select.
Now, press
several times forward (up to 9 programs) or press
several times backward (up to 8 ) to select the corresponding program
number.
(Fast forward:)
1.► 9
(Rewind:)
EX1. To select the current program again
press 3 (TPS), and press
once.
EX2. To select the 1st program backward
of the current selection, press 3(TPS)
once, and press
two times.
EX3. To select the next program, press 3
(TPS) and press
once.
EX4. To select the 3rd program forward of
the current selection, press 3 (TPS)
once, and press >►" three times.
0.0
, TI»
I k
0.0
-.TPS
J k
I
• To turn it off, press 3 (TPS) again.
Note:
The TPS mode may not work correctly in the following cases. This, however, does not mean that the unit is
defective.
• There is an interval less than 4 seconds or having a high level of noise or hum between programs.
• There is particularly low-level passage during the program.
□ Notes on Cassette Tapes
Tape Slack:
Use a pencil or similar object to take up the slack as
shown. If a loose tape is used, this may result in the
tape becoming tangled in the rotating parts of the
unit.
CQ-R545/R525/R520EUC
13
Publicité
