Publicité
Installing the
centre cover
22
21
23
Fitting the casing panels, adjust-
ing the seal
24
Installation instructions
The rotor hub is equipped with a grease fitting M6 (item 24) for continuous
Please
greasing of the bearings.
note
The hub cover features an aperture with removable plastic plug for accessing
the grease fitting. The removable plastic plug must be in line with the position
of the grease fitting.
- Fit the cover (item 22) using 10 bolts 4.2x13 (item 21) to the rotor struts (item 25).
The cover consists of two parts on each side.
One half contains the aperture for accessing the grease fitting. The aperture has a
removable plastic plug Ø40 (item 23).
If the TWHE has a removable front panel (see chapter "Preparation"), refit
the casing panels (item 4).
Around the periphery of the rotor (on front segment – item 26), adjust the
seal (item 27) using the brackets (item 28) so that the gap between rotor and
seal is at least 2 mm at the highest point. On the dividing strip (item 29) and
purging chamber (if installed), adjust the seal in the same way.
26
29
26
28
27
25
23
27
28
3065280_201804
24
Publicité
