Publicité
Step 1
Notch
11a
11a
12
10a
3065280_201804
Installation instructions
Place segment No. 7 onto the lifting equipment. Lift it to the installation height and
slide it onto rotor segment No. 6.
Place the segment onto the lifting equipment so the strut with the cut-out is
Please
facing downwards. This allows the centre bolt of segment No. 6 to slot into the
note
cut-out.
33a
1
Slide the segment all the way into its end position.
If, for weight reasons, the segment is in 2 parts, the inner part of
Please
segment No. 33a must be slid in first, followed by the outer part of No.
note
33b.
- Fit 2 fitting bolts M8x30 (item 11) and 2 bolts M8x25 (item 10) with nuts
M8 and washers (item 12) to the lower strut.
10
- In the upper strut, temporarily insert 2 fitting bolts M8x30 (item 11a) for
12
adjusting the position.
- Secure the upper strut in the centre using 1 bolt M8x25 (item 10a) and
nuts with washers (item 12).
11
- Fit 2 bolts M6x12 with washers (item 15) and nuts M6 (item 16)
12
– connection on the outer periphery.
10a
After adjusting and retightening the segment, remove the 2 temporarily
inserted fitting bolts M8x30 (item 11a). These are only permanently fitted
12
with the next segment.
33b
2
No.
7
No.
6
33
15
16
19
Publicité
