Publicité
EN
5. Use the device to style your hair. Tips
on using the attachments can be found
in the following section.
6. To switch off the device, slide the
switch
to the Off position
( Picture B: position b).
7. After using the device, disconnect it
from the mains power and let it cool
down.
Tips on Using the Attachments
1. Before you style your hair, give it a good
comb through to remove any knots.
2. To create curls, waves and volume or to
straighten the hair, divide it into sections
and then gradually treat the thinnest
possible strands of hair individually.
L
The thicker or longer the hair is,
the longer it will need to be treated
before you get the result you want.
3. Fix the individual strands in place with
cold air once you have shaped them.
4. After you have finished using the device,
allow the hair to cool down and only
then finish styling it with styling products.
•
Hairdryer attachment (1):
This attachment is used to dry the hair
in the same way as a conventional hair-
dryer. Point the opening of the attach-
ment towards the hair a short distance
away from it.
•
Diffuser (4) for gently drying curled hair:
Place the tips of a section of hair on the
diffuser and guide it towards the roots.
Hold it in position for a few seconds.
•
Round brush (2):
For smoothness and volume: Place one
strand of hair over the round brush at
the root. Then pull it slowly towards the
tips and turn in slightly as you do so.
14
For waves: Place the round brush on the
tips and turn in the strand of hair. Wait
for a short time and then fix in place
with cold air.
•
Comb attachment (3) For straightening
the hair: Move the comb attachment
slowly from the hair roots to the tips.
•
Curler for defining curls: Depending on
which direction you want the curls to
twist in, you can choose between the
left-turning curler (5) or the right-turning
curler (6).
Place the attachment on the tips of your
hair and move it slowly towards your
head. The flow of the air draws in the
strand of hair and wraps it around the
attachment. Briefly hold it in position,
fix in place with cold air and pull out.
CLEANING
Please Note!
■
Do not use any sharp or abrasive cleaning
agents or cleaning pads to clean the
device. These may damage the surfaces.
1. Make sure that the device has been
disconnected from the mains power
and has cooled down completely.
2. Take the attachment (1 – 6) off the main
unit (7) (see the "Attaching / Detaching
Attachments" chapter).
3. Remove any hair from all parts.
4. Wipe down the main unit (7) and the
attachment with a soft, damp cloth.
Then dry with a soft cloth.
5. Remove any dust or hair from the air
inlet (12). If necessary, carry out the
self-cleaning function (see below).
Publicité
