Publicité
8.5
Hammer / drill switch
▪
The hammer/drill switch can switch the drill, hammer and hammer/ drill functions.
▪
To set the function, please use below compounding of front and rear hammer/drill switch.
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use the chuck with SDS connector in combination with the
hammer/hammer drill function!
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
Copyright © 2024 VARO NV
POWE10060
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Chiseling or hammering in masonry, concrete
and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
P a g e
| 7
WARNING! No function mode:
The motor turns without load,
the shaft will not turn. Do not
set the switch like this. It may
damage the motor greatly.
www.varo.com
EN
Publicité
