Publicité
7 BEFORE USING THE TOOL FOR THE FIRST TIME
▪
Examine the place where the device is to be used for hidden electrical cables, gas and
water pipes using a pipe finding device.
▪
Before connecting to !he mains, ensure care that the mains voltage corresponds to the
details on the rating plate.
7.1
Fitting and changing tools (Fig. 2)
The device is equipped with a SDS-plus attachment system.
▪
Clean tools and grease with a thin layer of machine grease before fitting.
▪
Pull back fastening sleeve and hold.
▪
Push and rotate the dust-free tool into the tool holder as far as it will go. The tool will lock
automatically.
▪
Check that it has locked by pulling the tool
7.2
Removing SDS-plus tool
Pull back fastening sleeve, hold and remove tool.
Accessories can be hot after use. Don't touch the tip of accessory by hand!
Please always use protective floves to remove accessory.
8 OPERATION
8.1
Switching ON/OFF
▪
Connect the plug to the power supply. The power-on indicator (11) is illumed until the tool
disconnect from the power mains.
▪
Switching on:
▪
Switching off:
8.2
Handle attachment (Fig. 3)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop onto the neck
of the housing tool and position the handle, then tighten the handle attachment.
8.3
Depth stop
Loosen the handle attachment and place the straight part of the depth stop in the hole. Adjust
the depth stop and retighten the handle attachment.
8.4
Dust collection device (Fig. 4)
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
Copyright © 2024 VARO NV
Press the operating switch (8).
Release the operating switch(8)
POWE10060
P a g e
| 6
EN
www.varo.com
Publicité
