Symmons Identity S-6702 Manuel D'installation

S-6702
Tub/Shower System
Specification Submittal
Model Numbers

S-6702
Identity Tub/Shower System
Modifications
 -1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0
 2.0 gpm (7.6 L/min) flow restrictor
 -143 3 mode showerhead
-145
 5 mode showerhead
 -231 2 mode showerhead
-CHKS
 Integral check stops - for use in
installations where a positive shut-off
device is used downstream of mixing valve
 -IPS 1/2" female IPS connections
Less showerhead
 -L/HD
 -LP Loop handle
 -LR Lever handle
 -OP 13" oval plate
Rebuild trim kit
-REB-TRM

 -REV Reverse coring, hot on right, cold on
left, for back to back installations
 -SS Slip spout on any tub/shower unit
 -STN
Satin Nickel finish
 -TRM Trim only, valve not included
 -X
Integral service stops - allows water
shutoff at valve for service
Note: Append appropriate -suffix to model number.
Location:
Identity
™
Specification
Tub/shower system powered by the Temptrol
balancing valve. Features adjustable stop screw to limit
handle turn, integrated diverter, non-diverter tub spout,
1 mode showerhead with easy to clean rubber nozzles and
standard 2.5 gpm (9.5 L/min) flow restrictor. Components
made from metal and nonmetallic materials, plated in
standard polished chrome finish.
Compliance
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
2.0 gpm (7.6 L/min)
Print
pressure-
®
Certi ed by
CSA Group
Reset Form