Télécharger Imprimer la page

Enerwatt EW-3000 Mode D'emploi page 9

Publicité

Operation
1.
Turn On the inverter.
2.
Turn OFF the inverter.
3.
When you have confirmed that the appliance to be operated is turned off, plug an ap-
pliance cord into one of the two 110 V AC Outlets on the front panel of the inverter.
4.
Turn ON the inverter.
5.
Turn the appliance on.
6.
Plug in additional appliances and turn them on.
Note:
The audible alarm may make a momentary "chirp" when the inverter is turned OFF. This same
alarm may also sound when the inverter is being connected to or disconnected from the 12
volt battery bank.
Television and Audio Suggestions
Although all Enerwatt inverters are shielded and filtered to minimize signal interference, some
interference with your television picture may be unavoidable, especially in weak signal areas.
However, here are some suggestions that may improve reception:
1.
First, make sure that the television antenna produces a clear signal under normal ope-
rating conditions. Also, ensure that the antenna cable is properly shielded and of good
quality.
2.
Change the positions of the inverter, antenna cables and TV power cord.
3.
Isolate the TV, its power cord and antenna cables from the 12 volt power source by run-
ning an extension cord from the inverter to the television set.
4.
Coil the television power cord and the input cables running from the 12 volt power source
to the inverter.
5.
Attach a "Ferrite Data Line Filter" to the television power cord. More than one filter may be
required. These filters are available at most electronic supply stores.
Note:
Some inexpensive audio systems may produce a slight "buzzing" sound when operated with
the inverter. The only solution to this problem is to use a sound system with better power
supply filtering.
Operating a Microwave oven with your Power Inverter
The power rating used with microwave ovens is the "cooking power" which means the power
being "delivered" to the food being cooked. The actual operating power rating is listed on the
back of the microwave. If the operating power cannot be found on the back of the microwave,
check the owner's manual or contact the manufacturer.
9

Publicité

loading

Ce manuel est également adapté pour:

Ew-4000