Publicité
8.2
Handle attachment (Fig. 2)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Slip loop onto the neck
of the housing tool and position the handle, then tighten the handle attachment.
8.3
Dust collection device (Fig. 3)
Before carrying out hammer-drilling work vertically overhead pull dust collecting device over
the drill bit.
8.4
Hammer / drill switch
▪
The hammer/drill switch can switch the drill, hammer and hammer/ drill functions.
▪
To set the function, please use below compounding of front and rear hammer/drill switch.
Important! When hammer drilling you will require a low pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly. Re-sharpen or replace blunt drill bits.
Do not use a chuck with SDS connector in combination with the
hammer/hammer drill function!
8.5
How to use the demolition hammer
1.
After placing the tip of the tool on concrete surface, switch ON.
2.
By utilizing the weight of the machine and by firmly holding the demolition hammer with
both hands, one can effectively control the subsequent recoil motion.
Copyright © 2024 VARO NV
POWX1195
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don't use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
Chisel Rotation:
Non-working position used only to rotate flat
chisel into the desired position
P a g e
| 7
WARNING! No function mode:
The motor turns without load,
the shaft will not turn. Do not
set the switch like this. It may
damage the motor greatly.
www.varo.com
EN
Publicité
