Publicité
HEALTH TIP AND RECOMMENDATIONS
• Should you have any concerns about health issues, consult your doctor before using
the heating blanket.
• Do not use the heating blanket on parts of the body that are swollen, injured or
inflamed.
• Should you experience persistent pains in the muscles and joints, please inform your
doctor. Persistent pains can be a symptom of serious illness.
• If you experience any pain or discomfort while using the unit, stop using it immedi-
ately. Not intended for medical use in hospital.
ITEMS SUPPLIED AND PACKAGING
• Please check first of all that the unit is complete and is not damaged in any way.
• In doubt, do not use the appliance. Send it to a service point.
The following parts are included as standard:
- 1 heating blanket
- 1 instructions for use
The packaging can be reused or recycled. Please dispose properly of any packaging material no
longer required. If you notice any transport damage during unpacking, please contact your dealer
without delay.
WARNING
Please ensure that polybag packing is kept away from reach of children! Risk of suffocation!
OPERATION
• Plug the unit into the mains outlet and move the slider control form position 0 to posi-
tion 1. The power LED will light up in red. Then, you be able to feel the blanket getting
noticeably warmer. If you require a higher temperature setting, move the switch to the
next positions, 2 or to the maximum heat setting, position 3. If the blanket gets too hot
for you, move the slide back to position 2 or 1.
• The heating blanket cools down noticeably. To switch the unit off, move the switch back
to position 0. The red power LED will go out, indicating that the unit is switched off.
Unplug the unit from the mains outlet. Move the selector switch to position 1 for any
continuous use. If the appliance is slept on with the controls set to a higher temperature
the user may suffer skin burns or heat stroke.
• The heating blanket will switch off automatically and the LED light will blink after ap-
prox. 8 hours of continuous use. To switch it back on again, move the slider control to
position 0 and then back to the desired heat setting. Unplug the unit from the mains
outlet once you have finished using it.
12
Publicité
