Publicité
01 CHECKING THE
COMPONENTS
Surround Speaker X 2 / Speaker Cable / AC/DC
Adapter / Power Cord
NOTE
• For more information about the power supply and
power consumption, refer to the label attached to the
product. (Label: Rear of the Main Unit)
• Design and specifications are subject to change
without prior notice.
02 CONNECTING THE
SWA-9200S TO A
SOUNDBAR
1. Connect the Surround speaker cables
Use the speaker cables to connect the two surround
sound speakers.
• When connecting the speaker cable, connect the core
wire to the speaker.
• Insert the wire fully, taking care not to insert beyond
the wire insulation.
Insert the wire fully.
+ : Red
- : Black
• When connecting the speaker cables to the surround
speakers, follow these steps:
‒ Insert the red and black colored ends of each
speaker cable into the red and black jacks of the
appropriate speaker.
‒ The labels are on the backs of the speakers.
Audio cable
‒ The length of the speaker audio cable: 6 m
2. Turn on the Surround speakers
Plug the Surround speakers' power cord into an
electrical outlet to turn on the Surround speakers. The
LINK LED indicator(blue LED) on the rear of left surround
speaker will blink quickly.
If the LINK LED does not blink, please see step 6.
LINK STANDBY
"Blue
blinking"
Rear of Left Surround
3. Turn off the Soundbar
If the Soundbar is turned on, please turn off the
Soundbar by pressing the
Soundbar or remote control.
• The image of the Soundbar may differ from your
Soundbar, depending on the model.
ENG - 5
LINK STANDBY
ID SET
Rear of Left
Surround
LINK STANDBY
ID SET
(Power) button on the
BYE
OR
Red BlinksX3
Publicité
