Publicité
Assemble the brooder starting with the white plates. Attach the top plate (6) with the cable
•
through the U-shaped channel to the back plate (5).
After assembling the housing properly, screw the long screws into the holes in the outer walls of
•
the brooder, so that 5 screws are attached to the left and right-side plates, 9 screws to the back
plate and 9 screws to the floor plate (28 screws in total).
5. Warnings
•
This product is delivered with a UVB heat lamp, which is a type of heat source that simulates the
sun and has beneficial effects for animals. In case it breaks, it should be replaced with one with
the same characteristics. Under no circumstances, use energy-saving lamps, LED lights and other
cold light sources.
•
When using a chicken brooder, do not rely solely on the thermometer. It is best to observe the
activity status of the chicken: if the animals do not like to move and shrink into a ball, it is
recommended to increase the brightness of the light; if they open their mouths to breathe and
avoid the light, reduce the brightness of the light.
Newly hatched chickens and birds will not automatically drink water from the drinker, you can
•
pick up the chickens with your hands and put their beak in the water for two or three seconds,
then put them next to the drinker so that they learn to use it.
Newly hatched chickens must learn to use automatic feeders. At the beginning, you can sprinkle
•
feed into the brooder, and the chickens will feed automatically. When the temperature is high
during the day, it is possible to take the chickens out of the brooder and feed them using a
feeder.
EN
Publicité
