Publicité
6. Measure the clearance between the bottom of the extended blades and the ground.
• Minimum 50mm
• Note: in rough or lumpy paddocks the clearance needs to be increased to ensure that the blades don't
impact the ground in operation.
7. Adjust the roller height to increase or decrease the blade clearance as required
8. Go through steps 4-7 until the required clearance is achieved.
When the Flail Mower has been set up with the required tolerances:
Operate the Flail Mower with tractor in low range and the PTO delivering 540 RPM.
DRIVE BELT ADJUSTMENT
Loosen Screws A and B that lock the support shaft and loosen the counter nut C.
Loosen the screws that lock the gear box on the mounting plate D.
Adjust the drive belt tension. The correct belt tension is achieved when the belt can be deflected by the belt
thickness about 10mm at the center point between the pulleys.
Align the gearbox so the drive shaft is parallel with the body.
Use a straight edge to make sure the belt pullies are inline and running true. If misaligned, call your dealer or
service agent for technical support.
Fit the safety covers and tighten the mounting bolts before operation.
Approx.10mm
Deflection
Align with a
straight edge
BE-AGLxxxF USER MANUAL
9
Publicité
