Publicité
Machine stops
Machine pulsating
Machine often starts
and stops by itself
Machine starts but no
water comes out
14 WARRANTY
▪
This product is warranted as provided by law for a 36 months period effective from the
date of purchase by the first user.
▪
This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
▪
Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
▪
We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
▪
Repairs may only be carried out by an authorised customer service centre for Powerplus
tools.
▪
You can always obtain more information at the number 00 32 3 292 92 90.
▪
Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
▪
At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.
▪
Definitely excluded from the warranty is damage resulting from fluid permeation, excessive
dust penetration, intentional damage (on purpose or by gross carelessness), inappropriate
usage (use for purposes for which the device is not suitable), incompetent usage (e.g. not
following the instructions given in the manual), inexpert assembly, lightning strike,
erroneus net voltage. This list is not exhaustive.
Copyright © 2022 VARO
out or stuck
Water supply not
sufficient
Pump seals worn
Incorrect mains
voltage
Thermal sensor
activated
Nozzle partially
blocked
Amperage increase
Air in inlet
hose/pump
Inadequate supply
of mains water
Nozzle partially
blocked
Water filter blocked
Hose kinked
Pump and/or trigger
gun is leaking
No water supply
Water filter blocked
Nozzle blocked
P a g e
POWXG90430
Increase water pressure, check for blockage
of garden hose and/or change to bigger hose.
Contact your nearest service centre
Check that the mains voltage corresponds to
specification on the name plate
Leave the machine for 5 minutes to cool down
Clean the nozzle with a needle and by
spraying water backwards through the nozzle
Try without the extension cable.
Allow machine to run with open trigger until
regular working pressure resumes.
Increase water pressure, check for blockage
of garden hose and/or change to bigger hose.
Clean the nozzle with a needle and by
spraying water backwards through the nozzle
Clean the filter
Straighten out hose.
Contact your nearest service centre
Connect inlet water.
Clean the filter
Clean the nozzle with a needle and by
spraying water backwards through the nozzle
| 11
EN
www.varo.com
Publicité
