Publicité
7.3
Assembly of the handle (Fig. 3)
▪
Insert the two ends of the handle assembly into the two holes at the top of the base as
shown. Press the hoodle until it is inserted into the hoodle hole,and the handle is fixed
when you hear a "CLICK" sound.
7.4
Assembly of the high pressure hook (Fig. 4)
▪
Screw the high pressure hook to the handle
8 OPERATION
8.1
Connection of garden hose (Fig. 5)
▪
Before attaching the water inlet connector to the pressure washer remove the plastic cap.
▪
Attach the hose connector (with built-in filter) to pressure washer.
▪
Connect the garden hose with a standard quick coupling
8.2
Mounting of high pressure hose (Fig. 6)
▪
Screw the high pressure hose onto the water outlet pipe. Push and turn (clockwise) it tight
to avoid leakage.
▪
Screw the high pressure hose to the gun. Push and turn (clockwise) it tight to avoid
leakage.
▪
Remove, counterclockwise rotation.
8.3
Mounting turbo nozzle
1.
Place the turbo nozzle/patio cleaner into the trigger gun
2.
When inserted turn it. Caution: Make sure the lance is properly fixed to the gun
8.4
Water connection
An ordinary 1/2" garden hose of min. 10 m and max. 25 m will be suitable.
IMPORTANT! Only use water without any impurities. If there is a risk of
sand particles in the inlet water (i.e. from your own well), an additional filter
should be mounted.
1.
Let the water run through the water hose before connecting it to the machine to prevent
sand and dirt from penetrating the machine. Note: Check that the filter is fitted in the
water inlet pipe and that it is not clogged up.
2.
Connect the water hose to the water supply by means of the quick connector (inlet water,
max. pressure: 12 bar, max. temperature: 50°C).
3.
Turn on the water.
8.5
Start/stop of the machine
The trigger gun and lance is affected by a thrust during operation - therefore always hold it
firmly with both hands.
IMPORTANT: Point the nozzle at the ground.
This high pressure cleaner is equiped with an automatically sart/stop
system, based on waterpressure.
4.
Turn on the water supply.
5.
Release the trigger lock
6.
Activate the trigger of the trigger gun and let the water run until all air has escaped from
the water hose.
7.
Connect to power supply.
Copyright © 2022 VARO
POWXG90430
P a g e
| 8
EN
www.varo.com
Publicité
