Publicité
D
Dry all Aeroccino parts with a fresh and clean towel, cloth or paper and reassemble all parts.
CAUTION: Ensure the Aeroccino is cold before removing it from the base. Or, if removing with care, rinse with cold water
immediately to cool down the Aeroccino and avoid burning risks. / Do not immerse neither the Aeroccino nor the base in the water. /
In case the base needs to be cleaned, unplug it first and use only a damp cloth. Make sure the connector is dry before
operation. Do not immerse the base in water nor put it in the dishwasher. / If the bottom part of the Aeroccino is wet,
dry it before putting it back in contact with the base connector. / Only use non-abrasive cleaning materials. Do not use
abrasives, sharp objects, brushes: risk of scratches and harm to the Aeroccino coating.
TROUBLESHOOTING
Aeroccino does not start
Quality of milk froth not up to standard
Red Button blinking
Milk Overflows
SPECIFICATIONS
UM_AEROCCINO-V-Mini_Z1.indb 11
UM_AEROCCINO-V-Mini_Z1.indb 11
➔ Be sure to position the jug correctly on a clean base. Be sure to attach the whisk to the jug correctly
➔ Be sure to use whole or semi-skimmed milk at refrigerated temperature (39-43 F)
➔ Be sure to use the appropriate whisk and the jug is clean
➔ a) The appliance is too hot. Rinse it under cool water b) Whisk is missing c) Not enough milk. Fill milk frother up to one of the
two «max» level
➔ Be sure to use the appropriate whisk and check the corresponding indicator level
USA/CA:
120V, 60Hz, 450W
3597
BR/MX:
127V, 60Hz, 505W
AR:
220V, 50Hz, 410W
BR/CL:
220V-240V, 50-60Hz, 410-490W
AUS: 220-240V, 50-60Hz, 380-450W
29.07.24 10:15
29.07.24 10:15
EN
11
Publicité
