Publicité
Attaching the Seat
1.3
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. LOCATE THE "MINIMUM INSERTION" MARK
ENGRAVED NEAR THE BOTTOM OF THE SEAT POST.
3. HOLD THE SEAT IN POSITION ABOVE THE BIKE.
4. LOWER THE SEAT POST THROUGH THE CLAMP
AND INTO THE SEAT TUBE UNTIL THE MINIMUM
INSERTION MARK IS BELOW THE CLAMP.
NOTE: IF THE CLAMP OPENING IS TOO NARROW
TO RECEIVE THE POST, YOU CAN WIDEN
IT BY TURNING THE KNOB ON THE CLAMP
COUNTERCLOCKWISE WHILE HOLDING THE
LATCH STEADY.
5. WHILE HOLDING THE SEAT AT THE DESIRED
HEIGHT, CLOSE THE LATCH ON THE CLAMP.
SEAT POST
CLAMP LATCH
"MINIMUM INSERTION"
MARK
SEAT CLAMP
CLAMP KNOB
SEAT TUBE
21
Publicité
