Care And Cleaning - BASETech 2162728 Mode D'emploi

Error
The parking aid does not
switch on.
The display shows wrong
distance values and a signal
sounds although there is
enough room.
Repairs other than those described should only be carried out by an authorised
specialist.
It is forbidden to dispose of it in the domestic waste!

9. Care and Cleaning

Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions as they can cause damage to the housing and malfunctioning.
• Disconnect the product from the mains before each cleaning.
• Clean the outer sensors regularly to avoid malfunctioning. Clean the display with a clean,
damp and lint-free cloth without abrasive of chemical cleaners.
Possible cause
The reverse gear is not
engaged.
No ignition voltage.
Wrong cabling.
The fuse is defect.
The lateral slider is in the
"OFF" position.
Program error
The sensors are very dirty.
Solution
Engage the reverse gear
Switch the ignition on.
Check the plug connections
and the flat fuse of the
voltage supply.
Put the slider on "ON, Lo
or Hi".
Disengage the reverse gear
and engage it again (reset).
Clean the sensors regularly
27