Publicité
EN
Infinitely adjustable speed setting
Two rpm ranges can be pre-selected with the speed selector switch (4):
Gear 1 180-400 /min
Gear 2 300-700 /min
The necessary speed depends on the type of the material mixed and it is recommended to verify it by a practical test.
Maintenance, Cleaning and Storage
WARNING! RISK OF INJURY!
Switch off the tool and disconnect the power plug from the power outlet before performing any work on the tool.
Proper maintenance of the tool can prolong its life; the on/off switch must always be kept in good working order.
Mixing tools should be cleaned at the end of the job or when not used for a long period of time - Use a cloth to clean your mixer.
Running water or quartz sand can clean the mixing tools well. Do not use gasoline or strong solvents under any circumstances.
Do not allow liquids to enter the inside of the tool.
DO NOT cause any mechanical stress on the machine, such as compression, as this will cause unavoidable damage.
The mixing shaft must always be clean and free of dirt residues; - The spiral threaded hole must always be protected with a protective cover.
The air vents of the engine housing must not be covered when the tool is in operation. Do not operate the tool in the presence of flammable materials or
gases. Keep the tool's air ducts clean.
Store the tool and its accessories in an area free from moisture and out of the reach of children. The tool should always be used only in conjunction with the
manufacturer's original spare parts.
Carbon brushes should be checked and serviced when the tool's operating hours are approaching 60 hours, please replace in time in case of extensive wear
(only through an authorized service center).
Service
WARNING! Have your device repaired only by qualified specialist personnel using original manufacturer parts only. This will ensure that your device
remains safe to use.
WARNING! If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his agent in order to avoid a safety hazard.
This will ensure that your device remains safe to use.
Environmental disposal
In order to avoid damages on transporta on, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plas c components are marked according to their material, which makes it possible to
remove environmental friendly and differen ated because of available collec on facili es.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementaiton in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an
environmentally compatible recycling facility.
5
WWW.NIKOLAOUTOOLS.GR
Publicité
