Publicité
EN
EN
(8) Do not overload the machine!
(9) Do not use long extension cords when connecting the tool to the power supply. Do not pull the power cord to disconnect it from the power outlet,
disconnect it by pulling it from its power plug! Prevent exposure of the cable to high temperature, humidity and protect it from mechanical stress.
(10) Do not use power cables that are worn, cut or subjected to mechanical stress!
(11) Disconnect the power plug from the power outlet when the tool is not in use, prior to maintenance, adjustment or replacement of agitation
components!
(12) Do not use the tool for stirring materials that have a flash point below 210C .
(13) Do not use solvents to clean the tool components to guard against the risk of ignition!
(14) Do not operate the tool in areas where flammable materials or gases are present to guard against the risk of explosion.
(15) Do not operate the tool without the stirring attachment. Do not use the tool if the stirring container is not stabilized or for stirring materials inside a
moving container (e.g. concrete mixer)!
(16) Do not activate the tool before placing the stirring attachment inside the material in the stirring vessel!
(17) Do not operate the tool without load and do not increase the rotation speed when the agitation tool is outside the container and material!
(18) Do not empty the material from the container while the tool is in operation! Do not put your hands or other objects near the agitation attachment while
the tool is in operation.
(19) Do not operate the tool if the materials inside the container have solidified or frozen!
(20) Follow the instructions in the manual to operate the tool safely!
(21) Wear protective ear equipment and a safety mask while operating the tool!
(22) In case of repair or maintenance, choose only genuine manufacturer's spare parts!
Technical Data
Voltage/frequency:
Power:
No-load Speed:
Mixing paddle diameter :
Protective type/protective class:
No. of gears:
Tool fitting/Clamp thread:
Description of main parts (picture A)
1. ON / OFF switch
2. Switch lock
3. Speed control wheel
4. Speed selector switch
5. Tool mount
6. Supplementary handle
7. Ventilation apertures
8. Wrench
9. Mixing paddle
Operating instructions
WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work in the device.
Before operating
WARNING! DANGER OF INJURY! Switch the device off and pull the plug out of the mains socket before carrying out any work in the device.
Attaching a mixing paddle
NOTE: Use only paddles with the specified diameter.
- Screw the mixing paddle (M14) as far as possible into the tool.
- Tighten the paddle properly with an open-end wrench.
First use
The mains voltage at the socket must match that indicated on the technical data plate of the tool.
Basic operating instructions
Improper use may cause damage to the tool and equipment. Therefore, observe these instructions:
- Use a tool up to the specified diameter.
- Use the tool in such a way that its speed is not significantly reduced during operation or that it comes to a standstill.
Check whether the data on the tool's technical data plate corresponds to the actual mains voltage.
Switching on and off
- To switch on the tool, press and hold the on/off switch (1).
- If you release the on/off switch, the tool will be switched off.
Switch locking mechanism
You can lock the on/off switch by pressing the on/off switch (1) and then lock button (2). The switch lock can be released by briefly pressing the on/off
switch.
4
230 V/ 50 Hz
1800 W
I:180-400 (min), II:300-700 (min)
140 mm
Double insulation II
2
M14 x 2
WWW.NIKOLAOUTOOLS.GR
Publicité
