Publicité
▶
tWR
Determnes mnmum tme nterval between end of wrte data burst and the start of a
pre-charge command. Allows sense amplfiers to restore data to cell.
▶
tWTR
Determnes mnmum tme nterval between the end of wrte data burst and the start
of a column-read command; allows I/O gatng to overdrve sense amplfiers before
read command starts.
▶
tRRD
Specfies the actve-to-actve delay of dfferent banks.
▶
tRTP
Tme nterval between a read and a precharge command.
▶
tFAW
Ths tem s used to set the tFAW (four actvate wndow delay) tmng.
▶
tWCL
Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.
▶
tCKE
Ths tem s used to set the Pulse Wdth for DRAM module.
▶
tRTL
Ths tem s used to set Round Trp Latency settngs.
▶
Advanced Channel 1/ 2 Tmng Configuraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
▶
Spread Spectrum
Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng
clock generator pulses.
Important
•
If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
•
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
•
Remember to dsable Spread Spectrum f you are overclockng because even a slght
jtter can ntroduce a temporary boost n clock speed whch may just cause your over-
clocked processor to lock up.
▶
VDroop Control
Load lne droop controls the stream of current to the CPU.
[Auto]
Automatcally sets values for maxmum stablty.
[Low VDroop]
Provdes less fluctuaton (better for overclockng).
En-35
Publicité
