Publicité
Technical data
Category: Butane direct pressure
Gas Type: Butane
Cartridge: Butane 190 gr EN417-type200
Rated power: 1,100W
Consumption: 78g/h
Dimensions: 121 x 121 x 207mm
Net Weight: 0.44Kg
IMPORTANT!
1. Please read these usage instructions carefully to
familiarise yourself with the appliance before
connecting it to the gas cartridge.
2. Keep these instructions for future reference.
3. This device works with Super-Ego BTP C200 PRO
EN417-type200 cartridges according to EN417
standard.
4. Use outdoors or indoors in well-ventilated areas
only. Not to be used inside vehicles, caravans,
tents, boats or similar.
5. Keep the appliance out of the reach of children.
6. No Do not use the appliance if the seals are
damaged or worn.
7. No Do not modify the appliance.
Advertencia
− This appliance has been designed for domestic
use.
− Do not use if the ambient temperature is below
0ºC.
− The openings found in the stove support have
been designed to feed the gas combustion, do
not block them under any circumstances.
− Do not use the appliance if the gaskets are
damaged or worn, if you detect gas leaks,
the product is damaged or if it does not work
properly.
− The appliance must be used on a horizontal
surface.
− After each use, clean any food and especially
fat residues from the appliance.
− Never use the appliance near flammable
materials.
− Check that the cartridge is empty before
replacing it (shake it to see if there is any liquid
left inside)
− The butane gas cartridge must be changed in
10
a safe place, for example, in the open or in a
well ventilated location, preferably outside,
away from any ignition sources, such as naked
flames, and away from other people.
− If your appliance is leaking (you smell gas), take
it outside immediately into a well ventilated
location where the leak can be detected and
repaired. If you wish to check your appliance
for leaks, do it outside.
− Never use a flame to detect possible gas leaks.
Use soapy water.
− Do not shake the product before and/or during
use.
− Make sure the flame adjuster is fully closed
before inserting or changing gas cartridge.
− Do not make any alterations or attempt to
repair the device by yourself.
− If you have any problems, please contact our
repair service, or the dealer from whom you
bought the product.
WARNING!
Some parts may get very hot. Keep the appliance
out of the reach of children.
How to use (p. 6 and 7)
1.
packaging and place it in a horizontal
position on a firm and stable surface.
2.
check that the flame regulator is completely
closed (figure 2).
3. Unscrew the base cap and remove the empty
cartridge if necessary (figure 1a). Remember to
check that the cartridge is completely empty
before removing it.
4. Check that the connector pin is in perfect
condition (figure 3)
5. Insert the new cartridge and screw the base cap
back on. With the pressure exerted by screwing
on the lid, the connector pin will pierce the
cartridge, establishing a secure connection
between the stove and the cartridge. (figure 1b)
6. Next,
turn
counterclockwise and press the "PIEZO" button
until the ignition device activates. If it doesn't
ignite, repeat the operation.
7. Then turn the control knob to the desired
position.
ENGLISH
Remove the stove from the
Before inserting the cartridge,
the
flame
regulator
fully
Publicité
