Publicité
REAR PANEL
11. 5Vdc Power Jack: Connect the AC/DC adapter to receiver
12. Audio Output Jack 6.35mm: Connect the audio cable from this jack to the input port of amplifier, mixer.
13. XLR Balanced Output Jack: Connect the audio cable from this jack to the input port of amplifier, mixer.
MICROPHONE TRANSMITTER FEATURES
1. Grille: Protects the cartridge and helps reducing the breath sounds and wind noise.
2. Power & low battery indicator: Steady on when the mic is switched on and the batteries are full. Flashes
when the batteries run low and need replacement.
3. ON/MUTE/OFF switch: Switches the mic on or off.
TRANSMITTER BATTERY INSTALLATION
Rotate the lower part of the mic body to open the battery compartment. Insert 2x AA batteries with the correct
polarity. Close the battery cover.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in ac-
cordance with your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns.Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
SYSTEM CONNECTION
1. Receiver power connection: Connect the DC connector of the supplied AC/DC adaptor to the DC input
socket on the receiver. Plug the AC connector into an appropriate mains outlet.
2. Antennae: Keep the position of the antennae at an angle of 90°.
3. Audio connection: Connect the corresponding output of the receiver via a 6.35mm Jack lead to the input of
a power amplifier, mixer, etc.
TIPS TO ACHIEVE MAXIMUM PERFORMANCE
• Make sure you can always see the receiver antenna from the transmit-
ter position.
• Keep the distance from transmitter to receiver antenna as short as
possible.
• Avoid placing the receiver antenna near metal surfaces and obstruction.
• Monitor battery power and replace the battery as soon as the red light
goes on.
• If stacking or rack mounting receivers in a multiple system, do not allow antennae to touch or cross.
• Perform a walk-through before performance or presentation. If dead spots are found, adjust location of the
receiver. If dead spots remain, mark them and avoid them during performance.
• For a good operation, don't place the receiver near to sources of interference. Place the receiver in 1m dis-
tance from the ground and let at least 1m free space around the receiver.
4
Code: 15-3058PLS
PARTY-200UHF-MKII-2
Publicité
