Publicité
4.
Calculate the angle for the net you want to produce.
�� = ������
With
�� = ℎ�������� ���������� ���� ��������������
�� = ���������� ��������ℎ ���� ����
��
= ���������� ���������������� ���� ����
1
��
= ���������������� ���������������� ���� ����
2
Swirl calculator available at:
http://tools.pcm.ch/fr/thread-whirling-calculator/.
5.
Adjust the angle of the tool holder and block it with the
two rear screws [3], then fasten the two front screws
[4].
3
6.
To make an accurate adjustment of the whirler, use a
feeler on the reference side of the reglangle supplied in a
bag, which must first be attached to the housing [9].
(See reglangle instructions for use)
7.
Check the angle with the probe by moving the axis.
The measuring instrument should read ZERO.
Once the adjustment has been made, dismantle the
angle for production.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating
instructions
Betriebsanleitung
2 ∙ ��
−1
�� ∙ ( ��
+ ��
)
1
2
4
9
PCM Precision Tooling SA
Copyright © PCM Precision Tooling SA.
Validation: 26.03.2024
GSW164
8.
Correct the machining positions according to the
desired angle
�� = ℎ�������� ���������� ���� ��������������
∆��
∆��
For GSW161 with a standard PCM whirling head with B=21
∆�� = 5.3 ����.
then
SWISS MADE
Garant:
BT
∆��
sin �� =
∆��
= Y axis offset in mm
= ������������ ���� ������������ ���� ���������������� ���� ����
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
sales@pcm.ch
Document:
GSW164
Mode
d'emploi
Page: 4 de 4
Publicité
