Publicité
PRASTEL – UNIK2E230-BT
1st power on
When the system is switched on, the blue and red LEDs flash for 5s.
During this time, press BP1 to start learning the movements of the automated system.
After this time, you can :
- Start a START (step by step) with a pulse
- Programming a remote control :
1.
Press BP1 for about 5s
2.
The red LED lights up fixed
3.
Press a button on the remote control to be registered
4.
The red LED flashes to confirm the registration (if flashing fast = remote control already in memory)
5.
The system exits this mode after 10s
- Deleting registered remote controls
1.
Press and hold BP 1 for about 10s
2.
The red & blue LEDs will light up steady
3.
Release and press BP1 again
4.
The red LED flashes rapidly to confirm the deletion
- Automatic learning of the movements of the automatism
1.
Press BP 2 for about 5s
2.
The blue and red LEDs flash
3.
Release and press BP2 again
4.
The learning process starts
Download and install the "PrastelBT" application from your Android or Apple store.
Simplified Start-up
06-2023
4
Publicité
