Publicité
TURN OFF WATER SUPPLY
1. Close the main water supply valve, located near the
well pump or water meter.
2. Open all faucets to drain all water from house pipes.
NOTE: Be sure not to drain water from the water
heater, as damage to the water heater
elements could result.
INSTALL THE BRINE TANK OVERFLOW
ELBOW
Install the brine tank overflow grommet and elbow in
the 13/16" diameter hole in the back of the salt storage
tank sidewall.
NOTE: The brine tank overflow elbow accepts either
1/2" or 3/8" I.D. hose.
MOVE THE WATER SOFTENER INTO PLACE
Excessive Weight Hazard
Use two or more people to move and install
water softener.
Failure to do so can result in back or other
injury.
1. Move the water softener into the desired location.
Set it on a solid, level surface.
IMPORTANT: Do not place shims directly under the
salt storage tank to level the softener.
The weight of the tank, when full of
water and salt, may cause the tank to
fracture at the shim.
2. Visually check and remove any debris from the
water softener valve inlet and outlet ports. Carefully
remove the two large plastic clips (you will use
them).
3. Make sure the turbine assembly spins freely in the
"out" port of the valve.
4. If not already done, put a light coating of silicone
grease on the single bypass valve o-rings.
5. Push the single bypass valve into the softener valve
as far as it will go. Snap the two large holding clips
into place, from the top down as shown in Figures 9
& 10.
IMPORTANT: Be sure the clips snap firmly into place
so the single bypass valve will not pull
out.
Questions? Call Toll Free 1-866-986-3223
When you call, please be prepared to provide the model and serial number,
found on the rating decal, typically located on the rim below the salt lid hinges.
Installation Instructions
Nozzle
Venturi
Assembly
Nut -
Ferrule
Salt
Lid
Brine
Tubing
Salt
Storage
Tank
Stand
Tube
Channel
CORRECT ASSEMBLY
Clip
Outside diameter
of water softener
valve inlet & outlet
NOTE: Be sure all 3 tabs of the clip go through the matching
holes on the water softener valve inlet or outlet, and
fully into the channel on the single bypass valve.
Make sure that the tabs are fully seated.
whirlpoolwatersolutions.com
or visit
5
Top Cover
Brine Tank
Overflow
Elbow
Brine Tank
Overflow
Grommet
13/16" Hole
Brinewell
Cover
Brinewell
Float Stem
Brine
Valve
FIG. 8
Clip
Single Bypass Valve
FIG. 9
Outside diameter
of clip channel on
FIG. 10
single bypass valve
Publicité
