Publicité
Heat the point of the seam carefully until it
becomes pliable.
Note that there is not a great difference in
temperature between pliable plastic and
liquid plastic.
Apply the welding wire and allow it to flow
into the joint to form an even bead.
Soft soldering(see figure L)
For spot welding, fit the reduction nozzle
attachment (10). For welding pipes, fit the
reflector nozzle attachment (9). If you are
using solder without flux, apply soldering
grease or paste to the solder joint. Heat the
solder joint and apply the solder. The solder
must be melted by the temperature of the
workpiece. If necessary, remove the flux after
the solder joint has cooled down.
Heat-shrinking(see figure M)
Fit the reflector nozzle attachment (9). Choose
the diameter of the heat shrink plastic tube
suitable for the workpiece. Evenly heat the
heat shrink plastic tube until it fits closely
against the workpiece.
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
■ Clean the power tool and grille in front
of the vent slots regularly. Frequency of
cleaning is dependent on the material and
duration of use.
■ Regularly blow out the housing interior and
motor with dry compressed air.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
The instruction can also be available on
www.flex-tools.com.
16
Disposal information
WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
NOTE
Please ask your dealer about disposal
options!
Exemption from liability
The manufacturer and his representative are
not liable for any damage and lost profit due
to interruption in business caused by the
product or by an unusable product.
The manufacturer and his representative are
not liable for any damage which was caused
by improper use of the product or by use
of the product with products from other
manufacturers.
HG 650 2000
Publicité
