Publicité
6. Enclosure Configuration
6.1 Door Locks
The front and back doors have locks that are accessible using the included keys.
Note: Model CS16USB(W) does not contain a locking back door.
Each side panel locks using an L-shaped lever on the inside of the enclosure.
To unlock and remove the side panels, lift the shorter leg of the "L" up and pull it away from the
1
side panel. Pull the tab on the side panel and remove it from the enclosure.
To re-lock the side panels, secure it in the proper position, lift the shorter leg of the "L" up and
2
push it toward the side panel, back into the hole that it was in initially. Once it is in place, push
the shorter leg of the "L" down to lock it.
Note: To lock and unlock the side panels, you will need to have access to the interior of the enclosure.
6.2 Cable Access and Management
To connect the tablet charge and sync station to a power outlet, run the power cord through the top
or bottom cable access plate containing a cord grommet by unlocking the front door and removing
one or both of the side panels (as shown in section 6.1)
top or bottom cord grommet
2
. Then push the input plug through the
1
and run the cord to your nearest 3-prong, grounded wall outlet
1
2
.
3
2
3
6
CS32USB(W)
Publicité
