Publicité
ENERGY SAVING RECOMMENDATIONS
• The eco programme is suitable to clean normally soiled tableware, that for this
use, it is the most efficient programme in terms of its combined energy and water
consumption, and that it is used to assess compliance with the EU ecodesign
legislation.
• Loading the household dishwasher up to the capacity indicated by the manufacturer
will contribute to energy and water.
• Incorrect loading can have these consequences:
- a deteriorated cleaning result
- damage to property due to the blocking of the spraying arms.
• Manual pre-rinsing of tableware items leads to increased water and energy
consumption and is not recommended.
• Washing tableware in a household dishwasher usually consumes less energy and
water in the use phase than hand dishwashing when the household dishwasher is
used according to the manufacturer's instructions.
• The values given for programmes other than the eco programme are indicative only.
SETUP AND OPERATION
Starting the washing process
1. Pull out the lower and upper baskets, load the dishes and push the basket back in. It
is recommended to load the lower basket first and then the upper basket.
2. Fill in the detergent.
3. Plug the power plug into the mains socket.
4. Make sure that the water supply is set to full pressure.
5. Open the door and press the power button.
6. Select a programme, the indicator light lights up. Close the door and the
dishwasher will start its programme.
Changing the programme
A programme can only be changed if the appliance has only been running for a short
time. Otherwise, the dishwashing detergent may have already been released and the
dishwasher may already be full of water. If this is the case, the machine will need to be
reset and the dispenser will need to be refilled with detergent. To reset the dishwasher,
proceed as follows:
1. Open the door a little to stop the dishwasher. After the spray arm has stopped
working, you can open the door completely.
2. Press the programme button for more than three seconds to enter the programme
selection mode.
3. You can change the programme to the desired cycle setting.
EN
59
Publicité
