Publicité
OPERATING INSTRUCTIONS
LOCK AND UNLOCK
Lock: Press and hold the "
that the system has been locked and the system cannot be raised or lowered.
Unlock: Press and hold the "
to normal digital display, it means the system has been unlocked.
UP AND DOWN KEY OPERATION
When the "
" key is pressed, the desktop runs upward until it reaches the highest point of the
desktop.
When the "
" key is pressed, the desktop runs downward until it reaches the lowest point of
the desktop.
When the "
" or "
realize jogging.
LOCATION STORAGE AND MEMORY OPERATION
The hand controller in the picture above can store 3 memory points. The storage method is as
follows. When running to a specific point, press the "
"S-" and "
" will flash. At this time, press " H1-H3" key to store the current position to the
corresponding label.
In fully automatic mode (S-6 is 1), if you want to run to the memory point, you only need to click
the key corresponding to the storage location. At this time, the digital tube will display the height
of the corresponding key position, and then automatically run to the location stored.
Corresponding to the height, when running, any key can stop the system.
In semi-automatic mode (S-6 is 0), if you want to run to the memory point, you only need to keep
pressing the key corresponding to the storage position. At this time, the digital tube will display
the height of the corresponding key position, and then automatically run to the stored
height.While running, release the button to stop the system.
HIGH AND LOW LIMIT SETTING
The system supports desktop height limit. The operation method is: when you want to set the
current height as the desktop limit height, press and hold the "
corresponding height for 5 seconds. At this time, you will hear a buzzer sound, indicating
Restricted location storage successful.When the table is in the upper half of its travel, the upper
position is restricted. When the table top is in the lower half of its travel, the lower position is
restricted.
Cancel height limit Method 1: Reset the system at this time, and the system height limit will be
cancelled. Method 2: Let the desktop run to the limit high or low point. At this time, press and hold
the "
" and "
" buttons at the same time for 5 seconds. You will hear a buzzer sound,
indicating that the limit position is successfully cancelled.
" key for 5 seconds. When the digital tube displays "Loc", it means
" key for 5 seconds. When the digital display changes from "Loc"
" key is clicked, the desktop moves a small distance accordingly to
19 / 33
" button. The digital tube will display
" and "
" buttons at the
GIVE US A CALL: 1-844-416-2090
MON-FRI 8:30AM - 5:30PM (PT)
customerservice@eurekaergonomic.com
Publicité
