Publicité
Search for Outdoor Sensor
If you are seeing "NO" or dashes for your outdoor readings, please try the following steps:
1.
Hold the
TEMP
begin to animate.
2.
If after 3 minutes the sensor still isn't connected, bring the sensor inside, install
fresh batteries, then hold the
3.
If your outdoor data is still not appearing after these steps, please contact our support
staff at 1-844-687-4040 or via email at info@springfieldinstruments.com.
Extra Sensor Area
This station can display data for an add-on Rain Gauge as well as up to 3 additional Temp &
Humidity Sensors. These readings will all appear in the upper left section of the LCD in place of
the pressure reading.
Adding Sensors to Your Station
1.
Hold the
EXTRA
2.
Install batteries into your sensor. If the sensor has a
transmission signal. This button is usually located in or near the sensor's battery
compartment.
3.
Your sensor should connect within the next 3 minutes. The Sensor Reception Indicator
will show solid on the screen when a sensor is connected.
Viewing Add-On Sensor Data
If you have multiple add-on sensors connected, press and release the
toggle through the sensor data you'd like displayed on the LCD. The Auto Scroll Icon ( )
will appear if activated. This setting will also include relative pressure data in the cycle.
If you have a Rain Sensor connected, this will include viewing full rain history, as well as the
other extra sensors.
button to search for the outdoor sensor. The Reception Indicator
RESET
Rain
button until the Sensor Reception Indicator (
button to restart the station.
TX
Temperature/Humidity
) starts to animate.
button, press it to force a
EXTRA
will
button to
9
Publicité
