LIVARNO home HG08220 Instructions D'utilisation Et Consignes De Sécurité page 14

Do not install with sharp fasteners or nails.
Always unplug the power adaptor
the socket before installation, dismantling or
cleaning.
Never touch the power adaptor
LED tree itself with wet hands.
1
The product must not be electrically connected
to another device.
If the product is not in use for any length of
time (e.g. holidays), disconnect it from the
power supply.
If you have any questions about the product or
are unsure about any of its aspects, please
seek the advice of an electrical equipment
specialist.
The product is only suited for use with the
included power adaptor
JT-DC30V7.2W-H5-IP44).
Please note that the power adaptor
to draw a small amount of power even if the
product is turned off as long as the power
adaptor is plugged into a power outlet.
4
To switch the product off completely, unplug
the power adaptor
The LED driver can only be replaced by a
professional
The LEDs are not replaceable.
If the LEDs fail at the end of their lives, the entire
product must be replaced.
RISK OF EXPLOSION! Do
not use the product in explosive atmospheres
where flammable vapours, gases or dusts are
present.
Do not expose the product to any strong
vibrations or heavy mechanical stresses.
Make sure the lead wire
areas where lawn mowers, trimmers, scissors or
similar cutting tools are used.
RISK OF INJURY! Make sure
that, when the LED tree
and ground spikes
6
that they do not present any risk (e.g. risk of
stumbed by the stand or ground spikes).
The twigs of the LED tree
metal wire, which can cause scratches or dis-
coloration to delicate surfaces.
14 GB/IE
from
4
or the
4
(Model No.
4
continues
4
from the socket.
4
is not laid down in
2
is removed, the stand
1
are also removed, so
7
are made with
1
Installation
Note: Remove all packaging materials from the
product.
Remove the individual parts from the packag-
ing and mount the product according to figures
A–F. The site for the LED tree
lected in a way that it is erected on a solid,
level and vibration-free base.
Unfold the stand
6
Place the stand
6
(see fig. A).
For outdoor use: Anchor the stand
ground using the ground spikes
Insert the lower part
the stand and tighten the fastening screws
6
(see Fig. B and C).
Now insert the middle part
part of the LED tree
1c
into the middle part
Fig. D).
Bend the individual branches of the LED tree
to the desired shape (see fig. E). Remind not to
bend all the branches just to one side.
The lead wire must be unwound beforehand
2
when first use. Insert the connector of the lead
wire into the socket of the power adaptor
2
and tighten the screw connection, in order to
prevent moisture from penetrating inside (see
fig. F). Pay attention to the seal ring
plug the power adaptor
Setup the LED tree
make sure that the LED tree
Timer function
The timer button
3
1 x push of the button:
The product lights up continuously.
2 x push of the button:
The product lights up continuously for 6 hours and
then switches itself off for 18 hours. The product
will then switch on again for 6 hours at the al-
located time and then switch off for 18 hours.
must be se-
1
(see Fig. A).
on the selected location
to the
6
.
7
of the LED tree into
1c 1
into the lower
1b
. Then insert the tip
1
of the LED tree (see
1b 1
. Then
2a
into a socket.
4
firmly to the ground and
1
is stable!
1
has three functions:
5
1a
1
4