Publicité
I
NSTALLATION
MOUNTING
1. Determine where the speakers will be mounted. Ensure an area large enough for the speaker to
mount evenly. Be sure that the mounting location is deep enough for the speaker to fit; if mount-
ing in a door, operate all functions (windows, locks, etc.) through their entire operating range to
ensure there is no obstruction.
2. Refer to the specification chart to determine the proper diameter hole to cut for your speaker
model.
3. Using the plastic mounting ring as a template, mark the locations for the mounting screws. Drill
the holes with a 1/8" bit.
4. Feed the speaker wires through the cutout and the plastic mounting ring (from the flat side) and
connect to the speaker terminals. Be sure to observe proper polarity when connecting the wires.
The speaker's positive terminal is indicated with a "+".
5. Fit the ring and speaker to the cutout. Mount them using the enclosed screws. Fit the grille
inside the ring and press gently, but firmly, into place.
Mounting Ring
Grille
Example of standard
FEATURES
• Cone (polypropylene)
• Surround (foam)
• Tweeter (polyethermide)
Specifications subject
to change without
notice
4
All manuals and user guides at all-guides.com
Mounting Hole,
Cut-Out
Speaker
door installation
Model
Nominal Diameter (inch)
Nominal Diameter (mm)
Description
Nominal Impedance (ohms)
Frequency Response
Sensitivity (SPL@1w/1m)
Power Handling (Watts RMS/Peak)
Installation
Speaker Grilles
Mounting Diameter (inch)
Mounting Diameter (mm)
Mounting Depth (inch)
Mounting Depth (mm)
Grille
Mounting
Ring
Rear Deck
Cut-Out
Speaker
Example of 6" x 9" rear-deck installation
FFC65
6.5
165.1
3-way
4Ω
35Hz-22kHz
88dB
50/100
X
5-5/8
142
2-1/2
64
S
PECIFICATIONS
FFC69
6 x 9
152.4 x 228.6
3-way
4Ω
30Hz-22kHz
91dB
75/150
X
6-1/2 x 9-1/4
165 x 235
3
76
Publicité
