Publicité
OPERATING INSTRUCTIONS
3. Be careful not to splash water on the control panel or on the outside of the hot
water pot. Splashing can damage the unit and may cause an electric shock.
4. Close the lid by pushing down until you hear it click into place.
5. Connect the power cord to the unit, then plug it into an electrical outlet. The water
will automatically begin heating.
HOW TO DISPENSE HOT WATER
There are three ways to dispense water.
Push the manual
button on the lid.
REBOILING WATER
When the hot water pot is in Keep Warm Mode, press the REBOIL button to boil water;
the BOILING light will illuminate.
Once the water has reboiled, the KEEP WARM light will illuminate.
•
Before reboiling, ensure the water level is above the Refill (MIN) Guide Mark in the
•
water-viewing window.
The Reboil function will be deactivated immediately after the water has finished a
•
Reboil cycle.
10
Place a mug or cup under
the spout and press it against
the cup touch switch.
Press the dispense
button on the
control panel.
Publicité
