Publicité
PORTABLE PROPANE HEATER SAFETY WARNINGS
Know your product. Read operator's manual carefully.
Learn its applications and limitations, as well as the
specific potential hazards related to this product.
Following this rule will reduce the risk of electric shock,
fire, or serious injury.
Battery tools do not have to be plugged into an elec-
trical outlet; therefore, they are always in operating
condition. Be aware of possible hazards when not using
your battery tool or when changing accessories. Follow-
ing this rule will reduce the risk of electric shock, fire, or
serious personal injury.
Do not place propane heaters or their batteries near
fire or heat. This will reduce the risk of explosion and
possibly injury.
Do not crush, drop, or damage battery pack. Do not
use a battery pack or charger that has been dropped
or received a sharp blow. A damaged battery is subject
to explosion. Properly dispose of a dropped or damaged
battery immediately.
Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of open flame. An exploded battery can
propel debris and chemicals. If exposed, flush with water
immediately.
Do not charge battery tool in a damp or wet loca-
tion. Do not use, store, or charge battery packs or
products in locations where the temperature is less
than 50°F or more than 100°F. Do not store outside or
in vehicles. 40°C?
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water,
then neutralize with lemon juice or vinegar. If liquid
gets into your eyes, flush them with clean water for
at least 10 minutes, then seek immediate medical at-
tention. Following this rule will reduce the risk of serious
personal injury.
Do not incinerate the battery even if it is severely
damaged. The batteries can explode in a fire.
To reduce the risk of fire or electric shock, do not use
this product with any solid-state speed control device.
Not for use in kitchens, bathrooms, or other places
where water may be present.
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
Make sure your extension cord is in good condi-
tion. When using an extension cord, be sure to use
one heavy enough to carry the current your product
will draw. A wire gauge size (A.W.G.) of at least 16 is
recommended for an extension cord 100 feet or less
in length. A cord exceeding 100 feet is not recom-
mended. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord. An
undersized cord will cause a drop in line voltage resulting
in loss of power and overheating.
To reduce the risk of personal injury and electric
shock, the product should not be played with or
placed where small children can reach it.
To reduce the risk of electric shock, do not expose
to water or rain.
Never attempt to power the device with a battery pack
and extension cord at the same time.
The minimum surrounding air temperature rating for
this heater is OºF (-17ºC).
Not for use with ductwork.
When using propane:
Use the forced air heater only with propane and the regu-
lator/valve assembly supplied.
The hose assembly shall be protected from traffic, build-
ing materials, and contact with hot surfaces both during
use and while in storage.
Check for leaks prior to forced air heater operation. Do this
even if this forced air heater was assembled at the store.
Do not operate the forced air heater if there is a gas leak
present.
Never use a flame to check for gas leaks.
Propane gas is not natural gas. Do not try to convert this
forced air heater to natural gas as it will void the warranty
and is extremely dangerous.
Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage
of propane.
Do not store propane cylinders, gasoline, or other flam-
mable liquids in the vicinity of the forced air heater.
Shut down the forced air heater and allow to cool for five
minutes before changing the propane cylinder.
Do not smoke when attaching or removing the propane
cylinder.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions also.
5 - English
Publicité
