Publicité
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
■ Only replace the power supply cord with one of
the same type as the original: H07 RN - F (T40W
IC), SOOW (VHT446 IC). The same rule applies if an
extension is used.
■ The cable must be replaced by the manufacturer's
Service Center staff or by equivalent qualified
personnel.
Extensions
If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
The extension must have the same cross section of the power
cable.
Minimum section of extension cables:
Maximum length = 20 m
Cable = H07 RN - F (T40W IC), SOOW (VHT446 IC)
WARNING!
Sockets, plugs, cord grips, connectors and installation
of extension cord must maintain the IP protection
degree of the vacuum cleaner, as indicated on the data
plate.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
07/2014
Translation of the original instructions
Dry applications
The supplied filters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
Maintenance and repairs
WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to obtain another version/variant. The
plug must be removed from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■ Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately void the EC declaration of conformity
issued with the device.
5
T40W IC / VHT446 IC
[ NOTE ]
GB
US
C405
Publicité
