Publicité
NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back
and fully tighten all bolts. This will make the assembly easier.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Glue 16 Small Wood Dowels (5) into the inner holes on the File Drawer Side Panels (S and T) and Back
Panels (U) as shown.
NOTE: It is very important to use a small amount of glue on both ends of dowels and wipe away the
excess glue immediately with a damp cloth.
14
3. Orient and attach each File Drawer Back Panel (U) between the File Drawer Sides (S and T) with four
38 mm Screws (14).
File Drawer Assembling
S
5
U
5
T
T
5
14
S
U
Grooves line up with each
other and face inward.
9
5
x 2
5
x 2
Publicité
